| | |
| | - IP addressing and subnet masks are correct. |
| | - East is a Cisco router and West is a router from another |
| | vendor. |
| | |
| 22 | What should the administrator do to solve the problem? |
| | |
| | Enable the serial interface on West. |
| | |
| | Change the encapsulation on both routers to PPP. |
| | |
| | Add a clock rate on East. |
| | |
| | Replace the serial cable used to attach the CSU/DSU to West. |
| | |
| | Set the loopback interface on East. |
| | |
| | Bottom of Form |
|-------+----------------------------------------------------------------|
+------------------------------------------------------------------------+

+------------------------------------------------------------------------+
| | Top of Form |
| | |
| | The command show frame-relay map gives the following output: |
| | |
| | Serial 0 (up): ip 192.168.151.4 dlci 122, dynamic, broadcast, |
| | status defined, active |
| | |
| | Which three statements represent what is shown?(Choose three.) |
| | |
| | 192.168.151.4 represents the IP address of the remote router |
| | |
| | 192.168.151.4 represents the IP address of the local serial |
| 23 | interface |
| | |
| | DLCI 122 represents the interface of the remote serial interface |
| | |
| | DLCI 122 represents the local number used to connect to the |
| | remote address |
| | |
| | broadcast indicates that a dynamic routing protocol such as RIP |
| | v1 can send packets across this PVC |
| | |
| | active indicates that the ARP process is working |
| | |
| | Bottom of Form |
|----+-------------------------------------------------------------------|
|----+-------------------------------------------------------------------|
| | Top of Form |
| | |
| | What type of access control list must be used to create a |
| | reflexive ACL? |
| | |
| | any extended IP ACL |
| 24 | |
| | named extended IP ACL |
| | |
| | numbered extended IP ACL |
| | |
| | any standard or extended IP ACL |
| | |
| | Bottom of Form |
|----+-------------------------------------------------------------------|
+------------------------------------------------------------------------+

+------------------------------------------------------------------------+
| | Top of Form |
| | |
| | Refer to the exhibit. The network administrator creates a |
| | standard access control list to prohibit traffic from the |
| | 192.168.1.0/24 network from reaching the 192.168.2.0/24 network |
| | while still permitting Internet access for all networks. On which |
| | router interface and in which direction should it be applied? |
| | |
| 25 | interface fa0/0/0, inbound |
| | |
| | interface fa0/0/0, outbound |
| | |
| | interface fa0/0/1, inbound |